Scrollsaw Workshop Community -Please register to enable posting.
General Category => Ask Steve a question. => Topic started by: Coffeepot on January 28, 2018, 09:25:43 am
-
Referring to the Ichthys pattern, I need some more information please.
Being blonde, I missed the step after you find your angle. Where do you start cutting on the outside of the pattern? There's nothing shown like a starter point on the pattern. It appears to go from find your angle to push out the cut and glue. Would really appreciate the part in between...thanks.
-
I would suppose that you can drill the starter hole just about any place that is convenient for you. It would be a wise thing to drill the hole at the same angle as you are going to set your blade. And make sure the hole isn't too much bigger than your blade.
-
Thanks, RR. That's pretty much what I expected. I just would have really appreciated some visual aids to confirm what I think I might be doing. ???