Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: DanO on July 21, 2021, 06:11:55 pm
-
Started scrolling about 9 months ago. Steve's scrollsaw guy was my first attempt on a Wen 16". It didn't take long to realize I liked this new hobby and on Steve's recommendation I got the Delta 40-694. Couldn't be happier. Then I found a Tim Detweiler book and made a few of his patterns. I made the small ones first just to torture myself. Actually it was not too difficult. The 2 full sized locks are baltic birch and both snap closed like hungry alligators.
Now if I could just figure out how to post more than 1 picture at a time???
-
This one is Ash and Walnut. I made the 1/8" Walnut dowels with sand paper and a drill.
-
This is the inside of the Paduk and Maple.
-
Nice work!
Thanks for sharing and God Bless! Spirithorse
-
Great job. I believe you've "locked" yourself into the hobby of scrolling!
-
Nice work.
Larry
-
nice work, picture is good I still haven't learned how to post a picture
-
DanO your padlocks are superb. Thanks for sharing. Regards > GLC from Cypress, Texas
-
Nice work DanO. You have a nice choice of woods.
Karl
-
Great job!
-
Thanks everyone.