Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: Kristian on July 29, 2014, 11:25:03 am

Title: Squaredance sign
Post by: Kristian on July 29, 2014, 11:25:03 am

Hello Fellow scroller

I am a square dance caller here in Sweden and I was planning to surprise my
beginners with a gift when they have become graduated.
I do not know how I should cut out the picture I've attached here.

Is there anyone who can give a hint  ;)

Kristian ?ng / Sweden

Title: Re: Squaredance sign
Post by: spirithorse on July 30, 2014, 01:32:22 am

Hi, Kristian,
If you are cutting this from material about 3/8" to 3/4" (about 9.5mm to 19 mm I think) , you would just cut out the 3 areas in the center that would fall out and leave the entertwined squares.

If you want to cut it from thin material as a portrait, you would have to make
'bridges' between the areas that would fall out and the adjoining wood on the outside
of the pattern.

Good luck and God Bless! Spirithorse

Title: Re: Squaredance sign
Post by: Kristian on July 30, 2014, 07:46:35 am

Quote from: spirithorse on July 30, 2014, 01:32:22 am

Hi, Kristian,
If you are cutting this from material about 3/8" to 3/4" (about 9.5mm to 19 mm I think) , you would just cut out the 3 areas in the center that would fall out and leave the entertwined squares.

If you want to cut it from thin material as a portrait, you would have to make
'bridges' between the areas that would fall out and the adjoining wood on the outside
of the pattern.

Good luck and God Bless! Spirithorse

Thank?s spirithorse
for the quick answer but......
I?m not sure I understand the way you described.
Is it possible that you could make a simple drawing for me   please   ;)

Is was planning to put it on a candle holder

Kristian

Title: Re: Squaredance sign
Post by: spirithorse on July 31, 2014, 01:33:58 am

Hi, Kristian,
Please send your e-mail to spirithorse55@hotmail.com and I will send you two examples of
what I tried to describe.
God Bless! Spirithorse

Title: Re: Squaredance sign
Post by: Kristian on July 31, 2014, 10:58:34 am

Quote from: spirithorse on July 31, 2014, 01:33:58 am

Hi, Kristian,
Please send your e-mail to spirithorse55@hotmail.com and I will send you two examples of
what I tried to describe.
God Bless! Spirithorse

Hi Spirithorse
I have sent my email to you

Kristian