1
General Scroll Saw Talk / Dewalt 40-694 set up
« on: January 17, 2022, 12:03:12 pm »
Good morning all,
Just set up my new Delta scroll saw 40-694.
Have the table set in the indent and table at 0 deg.
However the saw blade is very close, like a out 0.006 the the left side (edge)of the hole.
Not sure how to adjust the table to move it or the blade to the center.
Any tips or hints would be helpful.
Thanks,
Jim
Just set up my new Delta scroll saw 40-694.
Have the table set in the indent and table at 0 deg.
However the saw blade is very close, like a out 0.006 the the left side (edge)of the hole.
Not sure how to adjust the table to move it or the blade to the center.
Any tips or hints would be helpful.
Thanks,
Jim