Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: Rodney on October 09, 2021, 10:23:35 pm
-
This is a Jim Blume pattern I cut using Pegas 2/0 and #1 spiral blades. The project is 1/4 maple plywood with a 1/4 pine backer board. The project was stained with Minwax Natural and the entire project was sprayed with 4 coats of gloss poly sanded between each coat. The frame is from framing material I had on hand.
-
Rodney,
Nicely done. Lot of detail and I really like the finish.
Mark
-
Hi Rodney,
I like the motif, your execution and the framing very much.
Greetings
-
Very nice work Rodney.
-
Great cut, Jim Blume is an astounding pattern maker