Scrollsaw Workshop Community -Please register to enable posting.
General Category => Tutorials, Techniques and Tips => Topic started by: agooday88 on July 10, 2014, 12:13:32 am
-
Hey there... I am probably the only one in here that doesn't know how to do this, but ya gotta learn some time. lol
I want to cut a name INTO a piece of wood. I drew the names with stencils but I cant figure out how to cut out some letters. The L and T and all those are easy but the ones with a hole inside are not making sense. Example.. when cutting a " A " .... I cut around the outside of the it I get a A with no hole in the middle. Same thing with an "O" I get a hole! I want to cut just a thin letter in the wood. Does that make sense?
How is this done? Please don't laugh at this post. I am a beginner and I am sure that this is a dumb question to a lot of you. :(
Thank u for your help. Have a Blessed Day! :D
-
Normally you have to use a font that is scrollable such as Freefrm 721 Blk, Stencil, Scrollsini, or similar.
You can use other fonts but, you have to make a 'Bridge' so that a section of wood is attached to
the piece that would normally fall out of the letters such as 'O', 'A', 'B' etc.
God Bless! Spirithorse
-
Certainly not a dumb question. If you search the internet for Freefrm 721 Blk you can clearly see what Spirithorse is talking about. Thanks for asking the question, now I know what font to use when I want lettering.
-
Here is another free font to eliminate the necessity of bridges when scrolling words into wood. Scroll down to "WordArt"
http://www.scrollcrafters.com/Pages/FreeStuff.aspx
It is quite similar to Hobo but without the need for the bridges.
-
Thank you for sharing!
-
Sharing and helping is what is all about - enjoy your scrolling, it is addictive.
-
you are not the only one who is finding words in wood a problem. Thanks for the tips.
-
I understand what you mean. thanks.. I will use that info. But what my problem is....I am making a heart and cutting out the word MOTHER in the middle of it. When I cut out the O and the R I had a big hole. I also cut out some stars with my kids name in it and the A was just a triangle. How do I get the middle of the letter? Or is there no way... lol I can accept that.