« previous next »
Pages: [1]   Go Down

Author Topic: Snip off pins?  (Read 1155 times)

Offline coachgrd

  • *
  • Newbie
  • Posts: 15
    • View Profile
Snip off pins?
« on: September 04, 2020, 06:54:08 am »
Hi everyone.  I decided after a month with the WEN, to return it.  The quality is just not there...this was apparent to me even being a newbie.  I decided to bump up to a Delta 40-694.  But, this leaves me with a fresh package of pinned blades.  Can anyone tell me if I can just snip the pinned portion of the blade off and use them in the Delta?

Thanks in advance.
~Gary
Logged

Offline Jimm

  • *
  • Newbie
  • Posts: 23
    • View Profile
Re: Snip off pins?
« Reply #1 on: September 04, 2020, 08:26:10 am »

Easier to just punch them out. I have done several of them and it worked fine.
Logged

Offline coachgrd

  • *
  • Newbie
  • Posts: 15
    • View Profile
Re: Snip off pins?
« Reply #2 on: September 04, 2020, 10:22:29 am »
Jimm...Can you elaborate how you did this without damaging the blade?
Thanks!
~Gary
Logged

Offline Jimm

  • *
  • Newbie
  • Posts: 23
    • View Profile
Re: Snip off pins?
« Reply #3 on: September 05, 2020, 10:16:17 am »
I set them flat on my vice jaws and tapped lightly with a small hammer they came right out. Had both sides supported by the vice.
Logged

Offline Norm Fengstad

  • ****
  • Sr. Member
  • Posts: 254
    • View Profile
Re: Snip off pins?
« Reply #4 on: September 05, 2020, 01:34:58 pm »
one could also take a piece of scrap drill a small hole lay the blade flat with the pin in the hole, gently tap the pin out
Logged

Offline SLIM

  • *
  • Newbie
  • Posts: 6
    • View Profile
Re: Snip off pins?
« Reply #5 on: September 08, 2020, 12:57:59 pm »
this is some great information. i was trying to figure the best way to accomplish the same thing, i was thinking grinding them off but punching out sounds like a better option.
thanks guys.
Logged
Pages: [1]   Go Up
« previous next »
 

SMF

Teknoromi

SMF Links

  1. XHTML
  2. RSS
  3. WAP2
  4. Theme by snrj