Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: gilljc on April 03, 2014, 12:24:13 pm
-
Want to say thanks to EIEIO for the patterns, my baby bandsaw wasn't up to cutting the compound pattern, but the morgan looks nice as a keyrack, done in local oak, unfinished as yet
-
Another nice one. Thanks.
Al
-
Nicely done. Thanks for sharing this with us.
DW
-
that's a great idea, making it into a coat rack. The cutting looks swell - is the wood thick? Looks like about 3/4".
The compound version really needs a bandsaw for the 1st cut unless you shrink the scale to tiny.
-
You did a great job, it looks great.
Marg
-
Again, thanks to Ray for the pattern, is about 7" x 4" by just under half inch thick my bits of wood are all less than 5" wide, so limited to wee things
-
Very good work, original and well done, thanks for sharing.
-
Looks really nice. I like the way you made it as a coat rack. Thanks for sharing it with us.
Nice pattern Ray.
-
Great work there, and very ingenious to turn it into a coat rack - very nicely done. Nice pattern too Ray.
-
that's a great project, nice grain in the wood.
-
nice work
-
Very nice cuttin and the pattern is great also, was it made available on site cause I musta missed it.
***Merlin***
-
Merlin - the pattern was not as a key hook, but here it is...
-
Thanks Ray much appreciated.
***Merlin***