Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: gordster on September 27, 2014, 05:59:30 am

Title: Steve's Christmas cross
Post by: gordster on September 27, 2014, 05:59:30 am: This is one of Steve's latest Christmas ornaments.I used 1/4 inch for the backer and cross and 1/8th for the merry Christmas...Christmas green and Christmas re colors....very easy to make...
Title: Re: Steve's Christmas cross
Post by: Bullfighter on September 27, 2014, 06:50:33 am: Nice work.
Title: Re: Steve's Christmas cross
Post by: newfie on September 27, 2014, 06:57:42 am: looks great thanks for sharing
Title: Re: Steve's Christmas cross
Post by: pierre62 on September 27, 2014, 07:06:04 am: Looks great thanks for SHARING
Title: Re: Steve's Christmas cross
Post by: DWSudekum on September 27, 2014, 08:20:56 am: Nicely cut Gordie. I have been thinking of doing that one. Thanks for sharing this with us.

DW
Title: Re: Steve's Christmas cross
Post by: Marcellarius on September 27, 2014, 09:47:58 am: that's very nice!!
Title: Re: Steve's Christmas cross
Post by: slowcutter on September 27, 2014, 10:19:22 am: Looks very nice

Like crosses,need to do that one
Title: Re: Steve's Christmas cross
Post by: frankorona on September 27, 2014, 11:02:14 am: Wonderful work, thanks for sharing.
Title: Re: Steve's Christmas cross
Post by: edward on September 27, 2014, 08:52:40 pm: I just started to cut one out, not sure when I will get it done, as I have other things to finish. Very nice cutting and the colors are right. edward
Title: Re: Steve's Christmas cross
Post by: Rover2 on September 27, 2014, 09:28:57 pm: Very nice work. Looks nice.
Title: Re: Steve's Christmas cross
Post by: Jim Finn on September 28, 2014, 09:33:03 am: I printed out that pattern myself. Yours looks perfect.
I think I will just use the pattern to inlay the letters into the cross.
Title: Re: Steve's Christmas cross
Post by: wombatie on October 06, 2014, 05:40:53 am: Very nice, I like it a lot.

Marg