Scrollsaw Workshop Community -Please register to enable posting.

General Category => Swap Shop => Topic started by: Bill P on November 09, 2012, 04:38:15 pm

Title: knobs for Excalibur
Post by: Bill P on November 09, 2012, 04:38:15 pm

I recently purchased the round knobs for the Excalibur, but my Arthur Itis doesn't let me get them as tight as the old ones, so if anyone would like a set for the price of shipping them, email me at bill_purcell3@q.com.

First email gets them.

Bill

Title: Re: knobs for Excalibur
Post by: Bill P on November 10, 2012, 06:30:53 am

And the winner is.......this is a drum roll......Dan Gallo!   :D

Bill

Title: Re: knobs for Excalibur
Post by: dgman on November 10, 2012, 12:41:07 pm

Yay!!!!! I don't have an Excalibur, but they should fit my DeWALT!

Title: Re: knobs for Excalibur
Post by: Keefie on November 13, 2012, 11:53:55 am

You beat me to it Dan, If they dont fit your DeWalt when you try it, send them to me please.

Title: Re: knobs for Excalibur
Post by: dgman on November 13, 2012, 03:55:18 pm

You got it Keith. I'll check them out as soon as I get them.

Title: Re: knobs for Excalibur
Post by: thumbs on November 16, 2012, 03:31:40 pm

They will fit--no problem there--it was very nice of you Bill--Richard

Title: Re: knobs for Excalibur
Post by: dgman on November 16, 2012, 06:12:00 pm

Yup, They fit, Thanks Bill!
Hey Bill, who is this Arthur Itis guy anyway? ::)

Title: Re: knobs for Excalibur
Post by: GrayBeard on November 29, 2012, 11:24:39 am

Dan, I guarantee you will recognize Arthur Itis when and if he comes to visit you!

~~~GB~~~

Title: Re: knobs for Excalibur
Post by: Bill P on December 08, 2012, 11:06:39 am

Art and I are very close; we're together 24/7.   ::)

Bill