Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: MadHatter on June 17, 2010, 09:01:46 am

Title: Cross
Post by: MadHatter on June 17, 2010, 09:01:46 am

this is from one of steves patterns (havent mounted it on the base yet). i enjoyed cutting this out, thank you steve.

[attachment deleted by admin]

Title: Re: Cross
Post by: Russ C on June 17, 2010, 09:03:42 am

Nice job, I like it. Thanks for posting your work.  8)

Title: Re: Cross
Post by: Marshall on June 17, 2010, 10:12:48 am

Nice job here  .........

Title: Re: Cross
Post by: cherie on June 17, 2010, 03:30:15 pm

Very nice job.  Crosses are getting to be so in.  Thanks for sharing.

Title: Re: Cross
Post by: rwb on June 17, 2010, 03:38:46 pm

good job on the cross

Title: Re: Cross
Post by: Dawie on June 22, 2010, 03:12:06 pm

Very nice.
David

Title: Re: Cross
Post by: Dan on June 25, 2010, 11:27:10 am

I have been wanting to cut that cross. How long did it take to cut?

Dan

Title: Re: Cross
Post by: MadHatter on June 25, 2010, 02:37:17 pm

hi dan, about an 1 1/2 hr to cut, the base(not pictured) i made an adjustment and used my router to make an inset, which made the cross more stable when glued.

Title: Re: Cross
Post by: Intarsia92 on June 25, 2010, 05:09:51 pm

Very Nice, Great Pattern

Title: Re: Cross
Post by: Caribbean Scroller on June 25, 2010, 06:01:39 pm

well done.

Title: Re: Cross
Post by: Dan on June 26, 2010, 12:05:27 pm

MadHatter.

I use a router on the base as well. I might use a #3 blade to cut the cross. Is that what you used?

Dan

Title: Re: Cross
Post by: MadHatter on June 26, 2010, 02:08:20 pm

hi dan, yes i use a #3 FD-XL blade(which is my fav overall to use). i use my router on a majority of my bases also.