Scrollsaw Workshop Community -Please register to enable posting.
General Category => Tutorials, Techniques and Tips => Topic started by: Buzz on December 04, 2020, 12:18:52 am
-
I have a Protech 3303 the upper arm does not raise up. I am trying to do the Santa pattern Steve put out the other day. I didn't know if there are any tips or tricks in getting the blade in the holes in the center of the big board 10" I have bent the blade trying to get it in the holes. Thanks in advance for any help.
-
It's better to bend the blade to the side instead of front / back, but there are still limits.
How easy/hard is it to clamp the blade top & bottom? You might have to put the blade through the wood and then clamp it. Might have to use a little blue tape to keep the blade from slipping out until you get it clamped.
Not having an arm that lifts is a definite restriction. Doesn't mean you can't do things, just means it's harder. But therefore more rewarding when you do succeed.
Good luck!
KCSteve :->