Scrollsaw Workshop Community -Please register to enable posting.
General Category => Tutorials, Techniques and Tips => Topic started by: tux_linux on July 27, 2011, 07:04:13 pm
-
I just found this table - makes it simpler to refer to the opposite value:
Conversion Table Inch / metric (http://www.torsten-harms.de/holz/div/ConversionTable.pdf) (PDF)
-
Perfect. Thanks!
-
Thanks, I use this tables often.
there was a topic before (http://stevedgood.com/community/index.php?topic=2670.msg22649#msg22649), with some wall charts (http://sawdustmaking.com/Free%20Charts/charts.html) with also drill bit speed, lumber dimensions, millimeter-inch chart and a woodscrew pilot hole guide.
-
I found this software for who is interested
http://www.filesweb.com/easy_unit_converter.html (http://www.filesweb.com/easy_unit_converter.html)
-
I just found this table - makes it simpler to refer to the opposite value:
Conversion Table Inch / metric (http://www.torsten-harms.de/holz/div/ConversionTable.pdf) (PDF)
Thanks for the tip! As i?m from germany it will be a great help.
-
Thanks for the tip.
I always I have to walk with calculator in hand to adapt the templates ...