Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: Spartan scroller on April 01, 2015, 04:01:26 pm

Title: Oval and regular key chain help
Post by: Spartan scroller on April 01, 2015, 04:01:26 pm

Hello again fellow scrollers. I have had a few requests for Steve's oval and regular key chain patterns.  There used to be a way when making several different ones you could save them all on one sheet instead of having to print them out one to a page thus going through a lot of paper. I did it before but can't remember how to do it.  Anyone help?

Terry

Title: Re: Oval and regular key chain help
Post by: don in brooklin on on April 01, 2015, 08:52:28 pm

With the key chain program you just have to hit enter after each name and it will put 5 per page.

don

Title: Re: Oval and regular key chain help
Post by: Spartan scroller on April 02, 2015, 09:10:34 am

Thanks Don. I'll give that a try.

Regards
Terry

Title: Re: Oval and regular key chain help
Post by: don in brooklin on on April 02, 2015, 02:15:29 pm

Hi

Oval key chain does not work that way. 

But you can export as BMP and then import to a program like Word or Gimp etc.

That way you could get a few per page depending on how big it is.

Don

If you are into Inkscape.  Export 1 to bmp.  Import into Inkscape.  Trace bit map. Duplicate and delete name.  Add you own name in font you want.

Now you can do about 3 per page and change the name there.