Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: DWSudekum on February 28, 2015, 07:36:11 am
-
I am working on a clamp / press for making bowls and banks and boxes. I had some left over water well pipe so I made a stand. The idea is to make a press that would be somewhat like one of those 20 ton bearing presses at Harbor Freight, but who needs 20 ton of pressure for wood hehe. So I drilled holes in the well pipe ( point E ) and put a removable cross bar between the pipes on both sides. I was able to get on the cheap some cut off stair tread ( point C ) that was being tossed at Home Depot. I planed both pieces flat and marked one upper and one lower. I purchased 2 5/8 in all thread that were 48 inches long and cut them in half. (Point A ). I drilled 1 inch holes in the four corners of the stair tread pieces and bolted the all thread to it. I then sleeved the all thread with some 1 inch pvc piping. The whole upper section is raised and lowered with an old ( 40 years ) scissor jack that I had laying around not using. This is still very much a work in progress however it does show promise.
(http://s6.postimg.org/jspw6sai5/22815_cd_004.jpg) (http://postimg.org/image/jspw6sai5/)
(http://s6.postimg.org/toqz6fga5/22815_cd_006.jpg) (http://postimg.org/image/toqz6fga5/)
DW
-
Interesting. Keep us posted.
-
Very creative, should work well.
-
Nicely done, DW,
Thanks for sharing and God Bless! Spirithorse