Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: DWSudekum on September 14, 2010, 08:15:41 pm
-
This is the mug pattern by Steve Good - Cut from 3/4 BB Ply. Stained a Golden Maple and then finished with tung oil. I figured that the ply on edge would look good.
DW
(http://img204.imageshack.us/img204/4349/mugj.th.jpg)
-
It does look good. Great job!
-
Looks pretty cool DW. Will the BB hold water?
-
Water in a Beer Mug ..... Please! I put a couple of coats of Polyurethane on the inside.
DW
-
OK, OK, I should of said " LIQUIDS"!
-
No, you should have said BEER!
-
I stand corrected again! :-[
-
Nice beer mug DW. I like the colr of the stain. 8)
-
Nice job DW. Cheers
Mark
-
that is an awesome mug!! love the finish on it too. :) thanks for sharing with us.
-
I would never have thought of plywood - it looks great!
-
Nice piece of work. Now I know that I can use plywood to make it, was thinking about it.
David
-
a really nice mug.
-
Verry god you did, thanks for sharing
-
That looks really good! Thanks for the picture of your work! Nice job!
-
That is a really pretty beer mug.