Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: bhenr99 on October 07, 2015, 11:39:29 am

Title: Office chair revise
Post by: bhenr99 on October 07, 2015, 11:39:29 am

I have to sit down when scrolling. A standard office height was a little to low. I looked for a higher one and could only find drafting chairs and they were to high. I found out you can replace cylinder on chairs very easy. The cylinders come in different sizes. I found the size I needed to raise a chair that I had up to a height that worked for me. Also the cylinder adjust for up and down.There are videos on the internet showing how to change cylinders. This way you can take any chair change the cylinder to work for your needs.

Bob

Title: Re: Office chair revise
Post by: dunk on October 07, 2015, 02:43:30 pm

Good info to have.  Thanks for sharing.