Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: Judy Hunter on February 15, 2015, 07:20:14 pm

Title: knobs
Post by: Judy Hunter on February 15, 2015, 07:20:14 pm

Does anyone know where I can get these small knobs?  The are 1inch high and 3/4 inch across.
Thanks in advance for any help  ;D

Title: Re: knobs
Post by: pddesertrat on February 15, 2015, 10:24:16 pm

I didn't look through all these but you might find them here:

http://www.rockler.com/hardware/knobs-and-pulls/wooden-knobs-and-pulls

If I needed some I would make them on my wood lathe.  Got a wood lathe?

Title: Re: knobs
Post by: jscott2 on February 15, 2015, 11:00:19 pm

Lee Valley http://www.leevalley.com/en/Home.aspx (http://www.leevalley.com/en/Home.aspx) might have them.

Jim

Title: Re: knobs
Post by: Kepy on February 16, 2015, 09:02:08 am

You might try Smithwood Products in Fort Worth.

Title: Re: knobs
Post by: EIEIO on February 16, 2015, 09:41:51 am

Judy - take a look here:
http://www.craftparts.com/knobs-wooden-c-197.html (http://www.craftparts.com/knobs-wooden-c-197.html)

I got 100 of their KP1250 for $9.00 and have used them for drawer pulls and feet. They take the Kreg fine thread washer head pocket screws and look nice.
 (http://www.craftparts.com/product_thumb.php?img=images/products/KP1250.jpg&w=119&h=117)

Title: Re: knobs
Post by: Rapid Roger on February 16, 2015, 10:50:24 am

Both my Ace Hardware and Hobby Lobby have a small selection of wooden knobs but, I don't know if they have a match for the one you pictured.
I have made my own knobs from time to time but, I don't have a lathe so I use the scroll saw (cut them like a 3-D pattern) and end up with square knobs or the drill press and a wood rasp. Needless to say, you have to start with a larger than necessary piece of wood and work it down until it is what you want and cut to length.

Rog

Title: Re: knobs
Post by: termite on February 16, 2015, 06:27:47 pm

Judy check out cherry tree catalog-cherrytreetoys.com-page 109. mushroom pull knobs .

Title: Re: knobs
Post by: tvman44 on February 16, 2015, 08:08:37 pm

Lowe's & home Depot have a few small wooden knobs.

Title: Re: knobs
Post by: Dan26 on February 16, 2015, 08:34:04 pm

Do you know someone that owns a lathe? If I was close my I would make them for you.

Title: Re: knobs
Post by: Judy Hunter on February 17, 2015, 11:05:38 am

Thanks everyone.  I have ordered the ones that were available.  I was just looking for that one in particular.
Fussy old Bag that I am ;D

Title: Re: knobs
Post by: TheMelster on February 17, 2015, 03:29:54 pm

 ;D ;D  try  www.meiselwoodhobby.com    located not too far from you!