Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: Judy Hunter on February 15, 2015, 07:20:14 pm
-
Does anyone know where I can get these small knobs? The are 1inch high and 3/4 inch across.
Thanks in advance for any help ;D
-
I didn't look through all these but you might find them here:
http://www.rockler.com/hardware/knobs-and-pulls/wooden-knobs-and-pulls
If I needed some I would make them on my wood lathe. Got a wood lathe?
-
Lee Valley http://www.leevalley.com/en/Home.aspx (http://www.leevalley.com/en/Home.aspx) might have them.
Jim
-
You might try Smithwood Products in Fort Worth.
-
Judy - take a look here:
http://www.craftparts.com/knobs-wooden-c-197.html (http://www.craftparts.com/knobs-wooden-c-197.html)
I got 100 of their KP1250 for $9.00 and have used them for drawer pulls and feet. They take the Kreg fine thread washer head pocket screws and look nice.
(http://www.craftparts.com/product_thumb.php?img=images/products/KP1250.jpg&w=119&h=117)
-
Both my Ace Hardware and Hobby Lobby have a small selection of wooden knobs but, I don't know if they have a match for the one you pictured.
I have made my own knobs from time to time but, I don't have a lathe so I use the scroll saw (cut them like a 3-D pattern) and end up with square knobs or the drill press and a wood rasp. Needless to say, you have to start with a larger than necessary piece of wood and work it down until it is what you want and cut to length.
Rog
-
Judy check out cherry tree catalog-cherrytreetoys.com-page 109. mushroom pull knobs .
-
Lowe's & home Depot have a few small wooden knobs.
-
Do you know someone that owns a lathe? If I was close my I would make them for you.
-
Thanks everyone. I have ordered the ones that were available. I was just looking for that one in particular.
Fussy old Bag that I am ;D
-
;D ;D try www.meiselwoodhobby.com located not too far from you!