Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: rwb on June 02, 2010, 11:27:00 am

Title: grandma otter
Post by: rwb on June 02, 2010, 11:27:00 am

just finished this one made out of 3/4 inch pine dont remember where i got it from

[attachment deleted by admin]

Title: Re: grandma otter
Post by: Russ C on June 02, 2010, 11:35:52 am

Nice work, good job. What type of blade did you use to cut the pine?  8)

Title: Re: grandma otter
Post by: rwb on June 02, 2010, 11:37:10 am

used 2/0 rev tooth

Title: Re: grandma otter
Post by: Russ C on June 02, 2010, 11:57:38 am

I use 3/4" pine too and that is the blade I choose. Tried using spiral one time, not sure why, on a pattern with a allot of cuts like yours. Did not like they way it cut in the pine at all. Went back to the 2/0 and sometimes 3/0 reverse tooth.
 8)

Title: Re: grandma otter
Post by: Dawie on June 02, 2010, 04:04:18 pm

Nicely done.
David

Title: Re: grandma otter
Post by: scrollgirl on June 03, 2010, 04:38:25 pm

That is really cute.  I used to go to Brookfield Zoo when I lived near Chicago and they had an otter tank and you could sit for hours and watch them swim. They were mesmerizing!  Great job!

Sheila