Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Dav on May 28, 2010, 07:30:18 pm

Title: cross
Post by: Dav on May 28, 2010, 07:30:18 pm

I would love to learn how to do the crosses in the egg..Is there a you tube vedio or pattern

Title: Re: cross
Post by: Barry on May 28, 2010, 09:50:23 pm

Hi Dav -

Steve has a video on you tube 

 http://www.youtube.com/watch?v=W8dgV2uYh

I made a number of them this past Easter.  I am not very computer literate if the address does not work just go to Steve's website and look under Scrollsaw workshop videos.  They turn out nice but instead of making a jig I cut the eggs in half it gives me a flat surface to steady my scrolling.  I would then glue the two sides back together.  After sanding and finishing you could not see the seam.  It will make more sense after you watch the video.

Barry

Title: Re: cross
Post by: Barry on May 28, 2010, 09:54:29 pm

 :( 

Like I said the address does not work.  Operator error (me)!  Go to Steve's site and you can find it.  Sorry.

Barry

PS:  Lots of folks don't know much about computers --- I don't even suspect anything!

Title: Re: cross
Post by: chips on May 29, 2010, 08:52:36 am

Dav,

Try this link to Steve's blog site. I think this is what your looking for. It's about halfway down the page.

http://scrollsawworkshop.blogspot.com/2009/04/true-meaning-of-easter.html

Title: Re: cross
Post by: Dav on May 29, 2010, 01:43:32 pm

thanks I found it and watched it

Title: Re: cross
Post by: Marshall on May 31, 2010, 10:37:24 am

Thanks a lot > enjoyed the video and also printed out the pattern . I would later like to try this > I would like to make several of these for the great people in my life , Thanks again ............Marshall