Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Marshall on April 19, 2010, 02:00:43 pm

Title: Remote Control Holder ! !
Post by: Marshall on April 19, 2010, 02:00:43 pm

Here's one of Steve's patterns I cut and I used Pine and stained it and sprayed several coats of clear poly on it ...........Marshall

[attachment deleted by admin]

Title: Re: Remote Control Holder ! !
Post by: bluto26101 on April 19, 2010, 03:14:21 pm

Good job.  Looks like you used 1/2" on the sides...did you use it on the fronts and bottoms too?

Title: Re: Remote Control Holder ! !
Post by: rwb on April 19, 2010, 03:17:55 pm

awsome work

Title: Re: Remote Control Holder ! !
Post by: EZgoing on April 19, 2010, 03:25:14 pm

 Very nice indeed! Thanks for showing it to us...

Ez

Title: Re: Remote Control Holder ! !
Post by: dunk on April 19, 2010, 05:45:19 pm

Nice job.

Title: Re: Remote Control Holder ! !
Post by: DJALDI on April 19, 2010, 06:56:09 pm

THANKS FOR SHARE IT WITH US REALLY NICE JOB

Title: Re: Remote Control Holder ! !
Post by: Marshall on April 20, 2010, 07:29:56 am

Yes Bluto I started out with the 3/4" material and milled it down to 1/2" size , thanks for the nice comments ........Marshall