Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Keefie on July 11, 2015, 04:28:25 pm

Title: House - Elves
Post by: Keefie on July 11, 2015, 04:28:25 pm

I havent been doing much cutting of late as I have been looking after my Dad, but I just managed to finish this one of Dobby from the Harry Potter films. Don R (Old Crow) was kind enough to turn my picture of Dobby into a pattern and I added the words to finish the pattern. It's cut from 4mm Birch ply and finished with one coat of sanding sealer and one coat of Celulose lacquer. Hope you like it.
Thanks again to Don R for the Dobby pattern.

Title: Re: House - Elves
Post by: Proxprof on July 11, 2015, 04:52:00 pm

You did a good job on that.
The pattern looks very good and the words just make sense.

Nice Job.

Title: Re: House - Elves
Post by: Donrob on July 11, 2015, 07:47:13 pm

Very nice Keith. Thanks for cutting my pattern.
Don R

Title: Re: House - Elves
Post by: DWSudekum on July 11, 2015, 08:18:33 pm

Very nicely done Keith.  That came out great.  I know several folks that could use that sign.  Thanks for sharing it with us.


DW

Title: Re: House - Elves
Post by: wombatie on July 13, 2015, 01:58:20 am

Well you haven't lost your touch. It looks great and you did a terrific job of the letters.

Marg

Title: Re: House - Elves
Post by: frankorona on July 13, 2015, 09:12:45 am

Great work, looks very nice. :) :) :) :)

Title: Re: House - Elves
Post by: EIEIO on July 13, 2015, 02:49:32 pm

Nice to see you're still into the dust. I've been out of the shop lately, but have a request for oak and walnut baskets for some high-end show this fall.