Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: almosttoogood on November 19, 2021, 11:04:20 pm

Title: Letters for 3 D cut outs ...
Post by: almosttoogood on November 19, 2021, 11:04:20 pm

Where can I find the letters like you use on the 3-D cut outs ? Thanks for your help ...

Title: Re: Letters for 3 D cut outs ...
Post by: don in brooklin on on November 20, 2021, 05:46:17 am

What are you trying to accomplish?

I used to do ribbon racks and when I started I used to use Wordart font so that I could cut on about 4 degrees and the letters pushed out about 1/8 inch.  See gymnastic picture below.

Found that limiting so I cut letters in any font and glued on.  See Coop.  I find that block letter look better.

Let us know more about project.