Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: Mimi on May 18, 2021, 08:52:33 pm

Title: Veteran Plaque
Post by: Mimi on May 18, 2021, 08:52:33 pm

i was wondering if a name could be added to the air force veteran plaque., If so I need name Robert Miller. put on it.  He is retiring from service in June. but would like to have it finished before then.
Thank you for all your help
Mimi

Title: Re: Veteran Plaque
Post by: spirithorse on May 19, 2021, 04:31:20 pm

Hi, Mimi,
Please send a link of the particular Air Force pattern you are speaking of.
You can add the name simply by typing in the name and using a font like
STENCIL or SCROLLSONI which work fine for scroll saw and size appropriately
if there is room on the pattern.
I'll do it if you cannot but, I need the size of the are that the name will be cut.
That's why I asked for a link to the particular pattern.
God Bless! Spirithorse

Title: Re: Veteran Plaque
Post by: Mimi on May 19, 2021, 07:32:39 pm

Is this what you mean https://www.stevedgood.com/airforcevet.pdf

Title: Re: Veteran Plaque
Post by: spirithorse on May 19, 2021, 10:15:13 pm

Thanks, Mimi,
I did not print this out but, looking at my graphics editor, it appears the
first and last name will only be about1 1/2 inches long. I don't know if
they will be scrollable at that size or not.
God Bless! Spirithorse

Title: Re: Veteran Plaque
Post by: Mimi on May 19, 2021, 11:28:38 pm

What about if you took off the words United States and put the name there. So it read Robert Miller air force veteran. Would that work .
Mimi

Title: Re: Veteran Plaque
Post by: HJones on May 21, 2021, 08:36:10 am

Hi Mimi,

Will this work for you?

Best Regard,
HJones

Title: Re: Veteran Plaque
Post by: spirithorse on May 23, 2021, 07:22:53 pm

Excellent job!
I hope Mimi could use your version of the pattern.
Thanks for helping out and welcome to the forum.
God Bless! Spirithorse Bob