Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: lefty55 on October 31, 2020, 11:32:45 am

Title: Looking for Pattern
Post by: lefty55 on October 31, 2020, 11:32:45 am

I think this is one of Steve's patterns, but I cannot locate it and failed to save it when I cut it.  Any help would be appreciated.

Title: Re: Looking for Pattern
Post by: don in brooklin on on November 01, 2020, 06:46:34 am

Not sure it is Steve's as I couldn't find but do you know the size.

I have a font very similar (Milkshake(=) and could come close or are you looking for the twin?

Title: Re: Looking for Pattern
Post by: KCSteve on November 01, 2020, 01:01:47 pm

Since I just grabbed it for another reply, here's the link to Steve's list of all the posts in case it helps you find it:
http://www.stevedgood.com/sswslist.html

Title: Re: Looking for Pattern
Post by: lefty55 on November 01, 2020, 02:03:29 pm

The ornament is 7 to 8 inches in diameter.

Title: Re: Looking for Pattern
Post by: don in brooklin on on November 01, 2020, 02:55:16 pm

Here is my version 1.  Let me know what you think.  If you send me your email I can send a PDF or svg and you can size as you want.

Not sure if size okay as it will only size be less that 128k

Title: Re: Looking for Pattern
Post by: spirithorse on November 08, 2020, 01:58:13 pm

That reminds me of Alex Fox designs.
You can see some of his patterns for sale here https://alexscrollsaw.wixsite.com/scrollsawpatterns

God Bless! Spirithorse