Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: spirithorse on March 27, 2018, 05:38:51 pm
-
one of Steve's more recent patterns.
Cut with #5 FDUR blade, 1/4" BB and 3/4" pine backer. No finish yet. Will be sprayed with Polyurethane Rattle Can spray.
Letters were modified on the fly for less blade entry holes.
God Bless! Spirithorse
-
That is a great looking piece! Nice work.
-
Very nicely done. Thanks for sharing this with us.
DW
-
I just finished the same one but I can't figure out how to resize the picture from my I phone to show it. Good job on yours
-
Thanks for all the kind comments.
Woodrush, if you send your photo from your phone to your computer and then open it in a program like Paint
you should be able to crop and re-size the photo.
I'd like to see it if you get the chance.
God Bless! Spirithorse
-
Unfortunately my computer is down and I can't afford a new one as I am saving to upgrade my saw. The only back up is my Samsung tablet
-
Very nice cutting - and just in season 🙏🏿👍
-
Good work...amen!
-
Love it , fine work too !
-
I have had this in my DO file for a while. But since I have viewed your Beautiful piece I shall get mine done.
As Always with your Scrolling.......Very well done.........Danny :+}
-
Looks great, well done
-
A super pretty pattern, your project is very nice!!
KNOW WHAT MOM KNOWS
Shelly Cole
aka "MOM" ;-)
-
Thanks for all the kind remarks and God Bless! Spirithorse