Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: rwb on May 06, 2010, 08:35:43 pm

Title: dragon
Post by: rwb on May 06, 2010, 08:35:43 pm

just finished it used 3/4 inch pine an light lacquer i dont remember where i got the pattern im going to use this for a lid on a box im making

[attachment deleted by admin]

Title: Re: dragon
Post by: shadylady0447 on May 06, 2010, 10:43:50 pm

Very nicely done!  I think the pattern is by Frieke. 

Title: Re: dragon
Post by: Barry on May 07, 2010, 12:13:49 am

Nice job Ron.  Thanks for sharing.

Barry

Title: Re: dragon
Post by: Dawie on May 07, 2010, 05:32:26 am

Very nice!

Title: Re: dragon
Post by: Marshall on May 07, 2010, 07:27:42 am

Another nice job Ron ..........

Title: Re: dragon
Post by: Joesawdust on May 07, 2010, 02:11:46 pm

Looks fantastic

Title: Re: dragon
Post by: MadHatter on May 07, 2010, 06:06:03 pm

very nice.

Title: Re: dragon
Post by: shissta on June 12, 2010, 09:53:33 am

Looks great.

Title: Re: dragon
Post by: Russ C on June 12, 2010, 12:39:51 pm

Nice job, I like it. Thanks for posting your work.  8)

Title: Re: dragon
Post by: cherie on June 17, 2010, 08:42:39 am

Dragon's are so awesome.  Nice job on the cutting.

Title: Re: dragon
Post by: Zohar on June 17, 2010, 01:37:02 pm

Real nice job, it would make an awesome box.

Title: Re: dragon
Post by: sp_343 on June 17, 2010, 05:46:08 pm

WOW...that is a fine job of cutting!

Title: Re: dragon
Post by: Dan on June 25, 2010, 11:43:29 am

What angle or degree did you use when cutting?

Dan

Title: Re: dragon
Post by: northie66 on June 27, 2010, 12:00:41 am

Cool.  I like dragons also :)