Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: DWSudekum on September 25, 2015, 03:03:33 pm
-
The backer for the sign is 3/4 pine. The sign itself is 1/4 Cherry. This is not for anyone specific, I cut it to be a display model for my shows. It will allow me to show what it might look like and to give them some idea of any changes that they would like to make when ordering.
(http://s6.postimg.org/j5r88t48d/92515cd_001.jpg) (http://postimg.org/image/j5r88t48d/)
This bowl was cut from my scrap pile. I had a section of 1/4 inch mahogany and a section of 1/2 lauan plywood. After gluing the mahogany to the top and bottom of the lauan plywood I cut this bow. It is 4 1/4 in diameter. Sealed with tung oil and shellaced.
(http://s6.postimg.org/87fyqmfn1/92515cd_002.jpg) (http://postimg.org/image/87fyqmfn1/)
(http://s6.postimg.org/l1e0jyt2l/92515cd_003.jpg) (http://postimg.org/image/l1e0jyt2l/)
(http://s6.postimg.org/6tobvbgdp/92515cd_004.jpg) (http://postimg.org/image/6tobvbgdp/)
DW
-
Excellent work, both are very well done. :D :D :D
-
I really like the bowel. Thanks for sharing.
-
Beautiful work!!
-
Nice bowl, now it just needs to be filled with Halloween snacks ;)
-
Beautiful looking bowl as usual DW. Family sign looks good too.
Marg
-
astonishing work , really great like all your work.