Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Danny on May 30, 2016, 04:03:44 pm

Title: Three Little Kittys.... :+}
Post by: Danny on May 30, 2016, 04:03:44 pm

Not really sure who designed this pattern.   Anyone know? 
Had a lot of fun cutting this.  Just had to make the Points Pointed best I could....
So as my always.  Love any comments....   Thanks for Looking.........................Danny  :+}

Title: Re: Three Little Kittys.... :+}
Post by: DWSudekum on May 30, 2016, 08:10:22 pm

You did a great job on those Danny.  The pattern was called something like Tribal Cats but I too can not remember who did it.  Thanks for sharing this with us.

DW

Title: Re: Three Little Kittys.... :+}
Post by: Wooden Lace on May 30, 2016, 09:00:58 pm

Nice job on these cats.  I was sure it was a Sue Mey pattern, but after looking through her site, I found some similar, but not this.  Then tried Sheila Landry, but again no luck.

Looked in my file under animals and there it was!  I downloaded mine from www.vecteezy.com, but when I tried finding it there again, didn't have any luck.  Found it on a site called QVectors, and it's a free download.

I've never heard of either of those sites before, and am wondering if it was something that Steve Good passed along. Hope this helps,
Nancy

Title: Re: Three Little Kittys.... :+}
Post by: TripleB on June 08, 2016, 11:20:41 am

Great job on cutting Danny, nice crisp and clean lines and the points look great too. This is a perfect example why I love flat blades. Bob

Title: Re: Three Little Kittys.... :+}
Post by: gordster on June 13, 2016, 06:37:08 am

Great job...Cat lovers would go bonkers over this..

Title: Re: Three Little Kittys.... :+}
Post by: 34natl on June 13, 2016, 08:33:52 pm

I am pretty sure its a Steve Good pattern.
Great job cutting it
Mike