Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Rodney on October 09, 2021, 10:23:35 pm

Title: Horse and Girl
Post by: Rodney on October 09, 2021, 10:23:35 pm

This is a Jim Blume pattern I cut using Pegas 2/0 and #1 spiral blades. The project is 1/4 maple plywood with a 1/4 pine backer board. The project was stained with Minwax Natural and the entire project was sprayed with 4 coats of gloss poly sanded between each coat. The frame is from framing material I had on hand.

Title: Re: Horse and Girl
Post by: Mark on October 10, 2021, 03:22:48 am

Rodney,
Nicely done. Lot of detail and I really like the finish.
Mark

Title: Re: Horse and Girl
Post by: Bluebird on October 10, 2021, 09:03:29 am

Hi Rodney,

I like the motif, your execution and the framing very much.

Greetings

Title: Re: Horse and Girl
Post by: DanO on October 11, 2021, 02:18:04 am

Very nice work Rodney.

Title: Re: Horse and Girl
Post by: Norm Fengstad on October 18, 2021, 08:18:57 am

Great cut, Jim Blume is an astounding pattern maker