Scrollsaw Workshop Community -Please register to enable posting.
General Category => Tutorials, Techniques and Tips => Topic started by: Lorace on February 18, 2016, 01:42:27 am
-
I am working on a new whirligig. and when cutting out my propellers, instead of using tape. ( which I was out of... and found this worked)
I got my hot glue gun out. and just did a few drops on each piece of wood, just made sure it was in the inside of my cutting area. and it worked so good. and then I just was able to flick the glue off. was a lot faster then tape, and did not have to stop to re tape to keep all together.
-
Hi Lorace:
Thanks for the tip
Will have to give this a go
Fab4
-
Excellent tip! I use my hot glue gun to hold the two pieces of wood together while doing double bevel inlay. After doing the inlay cut,I cut them apart with a razor knife.
-
Awesome tip! I'll def try it out! Thanks!