Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: DisabledVetWoodworker on February 26, 2018, 09:19:43 pm

Title: JESUS CHRIST block
Post by: DisabledVetWoodworker on February 26, 2018, 09:19:43 pm

Hi Steve,
Just wondered how you did the double line for any name, not just the above topic. Like if I wanted to put Mike Lusk  How would I put the Lusk under the "Mike" so I could do the same thing you did on the Jesus Christ sign? Thank you very much. I have downloaded your stencil program onto my son's pc desktop. Just don't know how to make the last name go under the first for the 1.5" inch block. Thanks...Michael

Title: Re: JESUS CHRIST block
Post by: don in brooklin on on February 27, 2018, 04:37:35 am

Did you check out Steve's Blog

http://scrollsawworkshop.blogspot.ca/2018_01_22_archive.html (http://scrollsawworkshop.blogspot.ca/2018_01_22_archive.html)

There is a link to have Steve do it for $5 too.

Title: Re: JESUS CHRIST block
Post by: DisabledVetWoodworker on February 27, 2018, 07:07:45 am

Well he all ready did it. I just wanted to know how he did it in his print program.