196
General Scroll Saw Talk / Re: I know it is not scrolling but
« on: January 01, 2013, 05:46:05 pm »
You can use almost anything, including corn cobs, pine cones, any interesting wood, etc.
News: Had a couple issues with the forum today. 1/19/2017. I believe I have them corrected now. Let me know if you have any trouble. Thanks.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
197
General Scroll Saw Talk / Re: 1/4" Baltic Birch Plywood, what's the best blade for splinter free cutting?
« on: December 17, 2012, 07:36:37 pm »
I tried the scrap wood on the bottom, still had some splintering. Then I tried a zero clearance hardboard top for the saw table, still some splintering. The Superior Puzzle blades I thought would be too slow going so I tried some FD #1 blades I had, turned the speed up and slowed my feed rate down a little. That seemed to do the trick. Thanks everyone for the ideas.
198
General Scroll Saw Talk / 1/4" Baltic Birch Plywood, what's the best blade for splinter free cutting?
« on: December 15, 2012, 05:31:52 pm »
Hi everyone,
I've been making Christmas ornaments out of 1/4" Baltic Birch Plywood. In the narrower areas, I have trouble with splintering the bottom veneer out of the plywood. I'm using FD #3 Scroll Reverse blades and change them every ornament. Is there a better blade for this or should I fabricate a zero clearance insert for the DW788? Thanks in advance.
I've been making Christmas ornaments out of 1/4" Baltic Birch Plywood. In the narrower areas, I have trouble with splintering the bottom veneer out of the plywood. I'm using FD #3 Scroll Reverse blades and change them every ornament. Is there a better blade for this or should I fabricate a zero clearance insert for the DW788? Thanks in advance.
199
Toy Makers / Re: NEED HELP FINDING - A MINI TOY CAR PATTERN
« on: December 02, 2012, 07:46:16 pm »
Another thumbs up for the Steve Good "2x4" vehicles!
200
General Scroll Saw Talk / Re: Trying to enlarge pattern ..need help
« on: December 02, 2012, 07:42:45 pm »
I do it with Corel (great program for patterns) or convert it to a PDF document and input the desired size wanted and it will print it "tiled".
201
General Scroll Saw Talk / Re: Dewalt Air Blower Broken
« on: November 30, 2012, 07:32:28 pm »
There is a tool available for assembling modular tubing, here's the link: http://www.modularhose.com/Loc-Line-14-System/14-miscellaneous I use these at work, MUCH easier than assembling with out it. Might not be worth if for a one time use though.
