Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: hurrysundown2 on September 02, 2015, 01:42:31 pm

Title: compound name plates help
Post by: hurrysundown2 on September 02, 2015, 01:42:31 pm

Hello hoping to make compound name plates.does anyone know how to print out these patters.Just over operation and will like to print out some patters then when I am feeling a little better cut them out.Thanks for any help.Hope I'm in right part of forum.    Tom

Title: Re: compound name plates help
Post by: herrwood on September 02, 2015, 06:12:05 pm

Not sure how complex you need but did you check the program steve has at the end of his web page. Its easy works well and ony request is a small donation to fund all he does

Title: Re: compound name plates help
Post by: hurrysundown2 on September 03, 2015, 06:20:30 am

Does the program have a name.I see DVDs or stencil printer ?

Title: Re: compound name plates help
Post by: herrwood on September 03, 2015, 06:49:56 pm

The stencil printer give it a try it works well for me