Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: cherie on July 16, 2010, 02:41:11 pm
-
I was able to purchase some plexi from the local window repair and made myself a new zero clearnance. Let me know whatcha think.
[attachment deleted by admin]
-
Me jealous. Looks very nice.
David
-
Good idea. Did you use carpet tape to hold it down?
-
Yes, I am using carpet tape to hold it down. I have to test it, eating lunch right now. LOL
-
Did this when I first got my new saw (cost me 20 nz dollars) I just use a couple of small clamps at the rear.
Merlin
-
Cherie. Good idea. I have some left over plexiglass, Im going to try that. Dave 8)
-
I have a can of "Slip-it" that we bought at Grizzly's. Took that stuff from the paper right off. I mean the paper stuff that comes when you buy plexi or acrylic. Now the table is very slick. LOL
-
It looks great, Cherie! :)
Sheila
-
What is the point of this? ???
-
Janet, since I mainly cut ornaments at this point of my life, they are fragile and a zero clearance helps with breakage and give more stability to the wood. The holes in many scroll saws are in my opinion are too big and with what little experience I have had, breaks many fragile areas.
I have also learned to put back the piece of waste that has been cut out, tape it back in place (like a puzzle) and it also adds stability to those really narrow areas of the wood.
I hope you can understand this explanation.
-
Oh, ok... I get it. Thanks for the explanation :)
-
don't you find that the flexing of the saw eventually makes the hole bigger?
Jimbo
-
I do, Jimbo. I make little 'disposable' ones out of plastic pop bottles and change them after every couple projects if I need to. But they last for a while anyway. I like Cherie's too! :)
Sheila
-
yes jimbo and if a blade breaks the hole becomes elongated!!!
-
I have plexiglass on my table top...works great...wood slides nice when cutting circles and corners...easy to clean.
-
Janet, since I mainly cut ornaments at this point of my life, they are fragile and a zero clearance helps with breakage and give more stability to the wood. The holes in many scroll saws are in my opinion are too big and with what little experience I have had, breaks many fragile areas.
I have also learned to put back the piece of waste that has been cut out, tape it back in place (like a puzzle) and it also adds stability to those really narrow areas of the wood.
I hope you can understand this explanation.
great idea, never thought of that.
I like to make small projects myself and this is a good tip!
Thank you Cherie
-
You are so welcome Marcellarius.
-
I cut one for my band saw [much bigger hole] and drilled holes in it to let the saw dust escape instead of it coming out the top
Jimbo