Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: Marcellarius on May 03, 2014, 01:47:29 pm
-
first key chain was a speed order and gone before I took a picture..
here are 4 more finished in 50/50 tung/orange oil mixture.
3 more are already cut, have to sand and finish them.
these for sold for ? 1,- per character so ? 22,- ($ 30,-) in total
-
Very nice work Marcel. Thanks for sharing these with us.
DW
-
Nicely done Marcel, but at 1 euro per letter plus the hardware seem a little cheap.
That hardware looks expensive, maybe not.... ::)
***Merlin***
-
Nice, good cutting. Where do you get the key chain part?
-
Nice work Marcel. Thanks for sharing.
-
thanks fort the nice words.
Nicely done Marcel, but at 1 euro per letter plus the hardware seem a little cheap.
That hardware looks expensive, maybe not.... ::)
***Merlin***
you might be right a little.....
but on the other hand, that and the saw blades are the only really cost I've to make.
I consider that as "tithe"/ contribution to the fund raising.
we discussed the price, we even set a limit on ? 7,50 for 8+ characters and we think that's what Dutch are prepared to pay for a key chain.
and I hope we don't names with 10 Characters ;)
think it would be to long anyway , can't bend your knee with such a long key chain in your pants ;D
Nice, good cutting. Where do you get the key chain part?
did buy them on a fair/flea market 200 pieces in an old ice cream box.
price was nice. don't know where he did get it.
just did look for some one Ebay (http://www.ebay.com/bhp/lobster-clasp-key-ring), just look for "Lobster Clasps Clips for Key Ring KeyChains"
-
I do key chains as well and buy my hardware in bulk to keep price down.
Here is my source. http://www.metalliferous.com/
-
Excellent work, fine cuts, thanks for sharing.
-
You have a good production going there Marcel. Good luck my friend your doing good.
Marg
-
Nice work thanks for sharing
-
Very nice work there Marcel and well done on all the orders.