Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Marshall Border on February 09, 2018, 08:38:59 pm

Title: Hogs plaques
Post by: Marshall Border on February 09, 2018, 08:38:59 pm

Made the two Razorback Plaques unfinished ones yesterday and today , Razorback and Hogs word  is cut from 1" Maple the base is 3/4" Maple material. I know it's a little thick for a scrollsaw but it looks better cut out of the thick material .  Have an order for four of these , any comments are welcomed .....

Title: Re: Hogs plaques
Post by: DWSudekum on February 09, 2018, 10:09:08 pm

Nicely done.  Thanks for sharing them with us.

DW