General Category > Tutorials, Techniques and Tips

Tape on partially finished work

(1/1)

overfifty:
I applied blue painters tape to a partially cut out pattern to keep some of the finer cuts from getting damaged and falling out. I then had health issues that prevented me from visiting the shop for several months and removing the tape. Now I'm concerned that the tape will do a lot of damage if I try to remove it. Is there something I can "wash" the tape with that will remove the tape and leave the work undamaged or stained. Thank you.

sardilou:
Hi
When I removed decals from vehicles we used a heat gun set low and applied hot air from a safe distance to the work this method softens the adhesive and is a clean solution a hair dryer will also work depending on the work you are applying heat to.

GLC:
The previously suggested heat gun work well to loosen the tape from your work or applying mineral spirits to the tape and let it soak in for a few moments.  Note: if you use mineral spirits on a rag to apply to tape dispose of the rag properly.  They can self combust!  When I use mineral spirits on a rag I take it out of my shop when I leave and place the rag spread out on my driveway to evaporate all of the mineral spirits.  Regards  >>  GLC in Cypress, Texas

overfifty:
Thank you very much. I'd put a lot of hours into the scroll work and didn't really want to have to do it again. Cheers!

Navigation

[0] Message Index