Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: jeff robinson on August 30, 2015, 10:38:15 pm

Title: Steve's Programs
Post by: jeff robinson on August 30, 2015, 10:38:15 pm

Steve,
Can I run your programs from a USB jump drive? I am teaching a scroll saw workshop at my local library and still waiting for there IT department OK, to be add to their server.

Title: Re: Steve's Programs
Post by: jscott2 on August 31, 2015, 02:30:07 pm

Jeff, from what I can see, the program is loaded into its own folder so it should run from a USB key.  The easy way to try it would be to install in a key, take it to another computer, and see what happens.

Good luck,
Jim