Scrollsaw Workshop Community -Please register to enable posting.
General Category => Pattern Requests. => Topic started by: Nbmartin on February 14, 2020, 10:14:28 am
-
Looking for intarsia pattern for a rooster.looked everywhere. Judy Roberts had one but UGLY. Need to make for birthday gift. Any help would be appreciated.
Thanks
-
Try typing in Intarsia Rooster using a search engine and you'll find a few patterns. I tried and found at least 3.
Good luck.
Karl
-
Kathy Wise has one in Scrollsaw Workshop mag issue 32 Fall 2008
It is for a napkin holder and could be made larger.
I did this on both sides.
-
Kathy Wise has one in Scrollsaw Workshop mag issue 32 Fall 2008
It is for a napkin holder and could be made larger.
I did this on both sides.
That’s a pretty one!