Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: DWSudekum on July 23, 2014, 08:59:59 pm

Title: Corian Panther
Post by: DWSudekum on July 23, 2014, 08:59:59 pm

This is a Steve Good Pattern and it is about 14 inches tall.  The corian I used was a sink cutout from a kitchen install.  The corian is 1/2 inches thick. I used a #9 ultra Reverse blade to cut the pattern.

(http://s6.postimg.org/3ruoe88fh/corian_panther_004.jpg) (http://postimg.org/image/3ruoe88fh/)

DW

Title: Re: Corian Panther
Post by: pierre62 on July 23, 2014, 09:03:33 pm

Thanks for sharing .

Title: Re: Corian Panther
Post by: pddesertrat on July 23, 2014, 09:31:12 pm

Really a great job.

Title: Re: Corian Panther
Post by: Pat W. on July 23, 2014, 09:59:23 pm

Very Very nice.   :)

Title: Re: Corian Panther
Post by: spirithorse on July 24, 2014, 01:35:51 am

Nice work, DW,
Thanks for sharing and God Bless! Spirithorse

Title: Re: Corian Panther
Post by: wombatie on July 24, 2014, 03:02:46 am

Veeery nice.

Marg

Title: Re: Corian Panther
Post by: frankorona on July 24, 2014, 08:11:10 am

Very nice job, looks great, thanks for sharing.

Title: Re: Corian Panther
Post by: Ray on August 02, 2014, 09:19:02 pm

Cool! I've always wanted to get my hands on some scrap Corian to try out.

Ray

Title: Re: Corian Panther
Post by: gordster on August 03, 2014, 04:05:01 pm

Great piece DW...nice cutting......Gordie

Title: Re: Corian Panther
Post by: newfie on August 03, 2014, 04:18:53 pm

nice work DW thanks for sharing