Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: scrollwizard on August 02, 2014, 03:13:55 pm

Title: Table numbers
Post by: scrollwizard on August 02, 2014, 03:13:55 pm

Hi Can anybody help, someon has asked me if I could make some numbers for their cafe tables. Any ideas would be greatly appreciated.

Dennis

Title: Re: Table numbers
Post by: Shogun on August 03, 2014, 09:26:44 am

Assuming the numbers would go on the edge of the table so the waitress could see them, I would cut them out if 1/4" hard wood of a contrasting color to the table. As far as how to affix them to the table you could use glue, epoxy, or pre-drill and use small screws or nails but that would be up to the owner.