Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: sawdust703 on February 08, 2015, 11:58:01 pm

Title: looking for a pattern of a combine
Post by: sawdust703 on February 08, 2015, 11:58:01 pm

Good evening folks! I'm on the hunt for a pattern of a Gleaner "L" combine runnin' in a wheat field. I've been lookin' for sometime with no luck. I've got a close friend that was a custom cutter, & run Gleaner L's for many years over several thousand acres, in several states. I'm trying to put a plaque of sorts together for him. Any help would be greatly appreciated. Sawdust

Title: Re: looking for a pattern of a combine
Post by: pddesertrat on February 09, 2015, 10:22:37 am

Someone may be able to make a pattern but they need a picture to do it with.  I found this picture on the internet.  Maybe it would work

Title: Re: looking for a pattern of a combine
Post by: sawdust703 on February 09, 2015, 09:21:44 pm

Thank you kindly, Sir.

Title: Re: looking for a pattern of a combine
Post by: daveo on February 10, 2015, 02:41:46 pm

this was the L2
best of luck and if you need the svg's just shout up

Dave

Title: Re: looking for a pattern of a combine
Post by: pierre62 on February 10, 2015, 04:53:41 pm

Nicely done daveo, thanks for your help.

Title: Re: looking for a pattern of a combine
Post by: Rover2 on February 10, 2015, 08:04:04 pm

Nice Pattern Dave.  Thanks for your help.

Al

Title: Re: looking for a pattern of a combine
Post by: sawdust703 on February 16, 2015, 12:13:57 am

Well done, Sir!! I greatly appreciate your time! I've been kinda busy with family matters lately, & haven't had much time to look this over. That will work great! Thank you again! Sawdust