Scrollsaw Workshop Community -Please register to enable posting.
General Category => Ask Steve a question. => Topic started by: Andy Ogden on January 30, 2018, 10:01:29 am
-
Try a machine shop to make you an adapter to receive both LH thread and thread for mop.
-
I sent Steve the following link. I think is going to check it out.
===============================
On my sanding station I use these. Is this the size you are looking for.
http://stockroomsupply.ca/shop/keyless-chuck.html (http://stockroomsupply.ca/shop/keyless-chuck.html)
I have a ½ Grinder with one and a 5/8 motor with the other
Good people to deal with. They are in Canada but ship to the US as they are close to border and attend a lot of US shows.