Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Cashew on May 19, 2020, 07:13:16 pm

Title: Experimental bowl completed
Post by: Cashew on May 19, 2020, 07:13:16 pm
Here's the completion of that experiment -- I did some more shaping with the Dremel and then applied Danish oil. I did end up with a crack in this one because when I went to glue the base on it slid sideways but i didn't catch it for about an hour. I separated it again (cracking it) and re-glued. I'll be trying it again shortly , only larger.
Title: Re: Experimental bowl completed
Post by: KarlB on May 20, 2020, 03:18:01 pm
That looks great.  It looks like a lot of work!

Karl
Title: Re: Experimental bowl completed
Post by: Cashew on May 20, 2020, 04:52:04 pm
Quote from: KarlB on May 20, 2020, 03:18:01 pm
That looks great.  It looks like a lot of work!

Karl
Title: Re: Experimental bowl completed
Post by: KCSteve on May 21, 2020, 03:00:47 pm
Looks good!

I give 'em about 5-10 minutes and then check to make sure everything looks correct.  It's also a good time to try to clean up excess glue.
Title: Re: Experimental bowl completed
Post by: Cashew on May 21, 2020, 11:10:48 pm
Quote from: KCSteve on May 21, 2020, 03:00:47 pm
Looks good!

I give 'em about 5-10 minutes and then check to make sure everything looks correct.  It's also a good time to try to clean up excess glue.