Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: Cashew on May 16, 2020, 02:20:43 pm
-
A little experiment I'm trying with my scroll saw -- a flower cut like a bowl -- still have some kinks and angles to work out -This is mostly freeform cutting based on an actual flower -- it's not something I've seen anybody try quite like this but I could have missed it somewhere -I think I may have to go bigger to make it work as an actual bowl - more shaping with the dremel to do also
-
Looks good so far. Very original and I haven't seen this done before.
Karl
-
Looks good so far. Very original and I haven't seen this done before.
Karl