Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Rodney on August 01, 2021, 10:26:59 pm

Title: Redeeming Myself
Post by: Rodney on August 01, 2021, 10:26:59 pm

I finally ran across some better material. This is one of Steve's patterns cut from 1/4 inch BB with Pegus #3MGT. They were stack cut and finished with natural and red pine Minwas stain. They were finished with four coats of gloss with light 350 grit sanding between coats. Must say I was much happier with the final finish than I was with my last project.

Title: Re: Redeeming Myself
Post by: Intarsia92 on August 02, 2021, 11:56:32 am

Very nice, Laos Great.

Title: Re: Redeeming Myself
Post by: DanO on August 04, 2021, 02:31:45 am

I like them.
A little elbow grease goes a long way. ;D

Title: Re: Redeeming Myself
Post by: Danny on November 04, 2021, 10:45:25 am

SURPRISE....SURPRISE....  I Really, really like the look of this Picture.  Very well cut and finished.  Danny  :+}

Title: Re: Redeeming Myself
Post by: Bluebird on November 04, 2021, 02:13:29 pm

Both of them turned out very well. I can't say which one I like better.

Greetings

Title: Re: Redeeming Myself
Post by: Norm Fengstad on November 09, 2021, 07:56:45 am

four light coats with fine sanding after each layer is worth the effort

Title: Re: Redeeming Myself
Post by: Marshall Border on March 07, 2023, 08:43:32 am

Been scrolling long enough too know these are time consuming , fine job.

Title: Re: Redeeming Myself
Post by: popsshop on July 24, 2023, 02:26:46 pm

Great cutting - really clean