« previous next »
Pages: [1]   Go Down

Author Topic: Finishing question  (Read 1248 times)

Offline Paw Paw Ray

  • ***
  • Full Member
  • Posts: 119
    • View Profile
    • Paw Paws Workshop
Finishing question
« on: September 16, 2013, 11:42:12 am »
What finish can you put on wooden coasters that will not leave a white ring after putting a cup of coffee or glass of water on the coaster?  I know shellac will not work.
Logged

Offline BilltheDiver

  • *****
  • Hero Member
  • Posts: 1475
    • View Profile
Re: Finishing question
« Reply #1 on: September 16, 2013, 04:15:38 pm »
Polyurethane or epoxy
Logged
"Measure twice, cut once, count fingers"

Offline Rapid Roger

  • *****
  • Hero Member
  • Posts: 1468
  • Hutchinson, Kansas
    • View Profile
Re: Finishing question
« Reply #2 on: September 16, 2013, 05:25:21 pm »
I second what Bill said.
However you can use shellac or BLO to seal and/or pop the grain to start with as long as you finish up with two or three coats of poly or epoxy as a protective coat.

Rog
Logged
An ounce of responsablity is worth 10 pounds of state and fedral laws.
Pages: [1]   Go Up
« previous next »
 

SMF

Teknoromi

SMF Links

  1. XHTML
  2. RSS
  3. WAP2
  4. Theme by snrj