Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: Bucko on October 13, 2019, 04:21:21 pm

Title: Finish on Steve’s Medallion ?
Post by: Bucko on October 13, 2019, 04:21:21 pm

 For the first time I am going to use 1 of Steve’s custom medallions on the side of a small Rocking Horse . If I put it in the drilled shallow hole just before I finish with clear polyurethane will it appear ok or should I put in place later and not apply the clear polyurethane over the medallion? Thanks!

Title: Re: Finish on Steve’s Medallion ?
Post by: GLC on October 14, 2019, 10:47:22 am

I use the medallions on some pieces and my preference is io install them 1st and then apply a clear satin finish.

Title: Re: Finish on Steve’s Medallion ?
Post by: Bucko on October 15, 2019, 08:36:19 am

Thanks so much

Title: Re: Finish on Steve’s Medallion ?
Post by: Bucko on October 31, 2019, 08:27:47 pm

One coat of clear satin finish on my Rocker Horse looks great on both horse and medallion.

Title: Re: Finish on Steve’s Medallion ?
Post by: GLC on November 01, 2019, 11:00:22 am

Glad it pleased you.  Do you have a pic you can share?  Regards, GLC in Cypress, Texas.

Title: Re: Finish on Steve’s Medallion ?
Post by: Bucko on November 02, 2019, 02:27:01 pm

Unless I’m missing something a picture from my iPad doesn’t meet forum requirements for posting after trying several times. May have to get the camera out and add picture to pc .

Title: Re: Finish on Steve’s Medallion ?
Post by: GLC on November 02, 2019, 03:40:24 pm

I've heard others comment that there can be an issue with the file size of pics.  Probably too high a resolution.